Gainsborough K244 Assembly Instructions/Instructions For Use

Set 4 Bronze Lawn Edging with Solar
Lights
K244 v02: 17/01/22
Please read and retain these instructions for future reference
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Before using first time
Allow lights to charge for at least 8 hours in full sunlight with the ON/OFF switch in the ON position. The
ON/OFF switch is located under the solar panel. Once the batteries are fully charged, set the ON/OFF switch
to ON. If the lamp does not turn on after dark refer to Maintenance section.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically
Parts
BEFORE FIRST USE: Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. Set button (located underneath solar panel) to "ON" position. Charge the solar product by placing it
under direct sunlight for at least 8 hours.
2. The light will work automatically. It will automatically charge under direct sunlight during the daytime
and illuminate at night.
Always position in direct sunlight
Dimensions
(H) 34 x (W) 49 x (D) 2.2cm
•
POLYSILICON SOLAR PANEL 2V 70MAH
•
SOLAR PANEL STAKE – 1M AWAY
•
2 IN 1 CREATE A BORDER AND LIGHT UP THE
WALK WAY
•
113CM WIRE BETWEEN EACH SECTION OF
BORDER
1 x 1.2V Ni-MH AA 400mah Rechargeable