Page 1
Access & Power Integration T1RHW3F4 Fully assembled kit includes: - Trove1R rack enclosure with Altronix/Honeywell backplane (THW1R) - (1) eFlow6NB - Power Supply/Charger - (1) VR6 - Voltage Regulator - (1) PDS8 - Fused Dual Output Power Distribution Module - (1) ACM4 - Fused Access Power Controller Installation Guide All registered trademarks are property of their respective owners.
Page 2
Overview: Altronix T1RHW3F4 rack kit is pre-assembled and consists of Trove1HW1R enclosure/backplane with factory installed Altronix power supply/charger and sub-assemblies. This kit also accommodates various combinations of Honeywell boards for up to four (4) doors in a single enclosure. Configuration Chart:...
Page 3
1. Remove backplane from enclosure prior to installing into rack cabinet (do not discard hardware). 2. In order to mount included UL Listed tamper switch (Altronix Model TS112 or equivalent) turn the enclosure upside down. Punch out the knockout in designated location, on the back of the unit, from outside of the drawer (Fig.
Page 4
Assembling and Attaching Z Bracket Wire Management Accessory (included): Altronix Trove Rack enclosures include Z Bracket, a convenient and reliable wire management accessory. Hardware (included): Fig. 3 Ten (10) bolts and eight (8) lock nuts. 1. Carefully unpack Z Bracket. Do not discard hardware (included) (Fig.
Page 5
Access Controller Position Chart for the Following Models: Honeywell Board Pem Mounting PRO32E1PS, PRO32IC, PRO32R2, PRO32IN, PRO32OUT, PW6K2E2PS, PW6K1IC, PW6K1IN, PW6K1OUT, PW6K1R2. Fig. 5 To IEC connector Altronix eFlow6NB PWR1+ PWR1+ Altronix PDS8/VR6 OUT1 OUT2 OUT3 OUT4 OUT5 OUT6 OUT7 OUT8 COM(-) Fig. 5a...
Need help?
Do you have a question about the TROVE T1RHW3F4 and is the answer not in the manual?
Questions and answers