Hotpoint Ariston VS S15 AAW Operating Instructions Manual page 20

it en
Never store the device with the wet cloth on
it. The residual humidity can cause strong
odours or mould build-up.
Should you decide not to use the device for a
store the device.
CARPETS CLEANING (D)
Do not use the device without applying the
cloth on the base of the main brush.
Before using the device, please remove any
residual dirt.
1. Please apply the cloth on the suitable steam
cleaning tool (16) and connect everything to the
main brush (1).
2. Unwind the power cable (12) and insert the plug
of the device in a wall socket (220-240V).
3. Position the device on the carpets tool (17).
4. Select the steam mode by turning the power
electronic regulator anticlockwise (3) in order
start the device in steam mode. Position the po-
wer electronic regulator so that it is in line with
the symbol .
heat up (20 seconds).
5. Select the amount of steam you want (according
to the surface to be cleaned) by acting on the
steam selection button (4)
6.
the power electronic regulator clockwise by
positioning it in line with the Off symbol.
7. Let the device cool down for about 3-5 minutes
on the carpets tool (17) before you put it back.
After being used, the device is hot and the
cloth is wet. Pay attention! Do not damage
8. Wind up the cable.
9. Remove the cloth.
Never store the device with the wet cloth on
it. The residual humidity can cause strong
odours or mould build-up.
Should you decide not to use the device for a
store the device.
Before carrying
maintenance procedure, make sure you
unplugged the device from the wall socket. To
20
out cleaning and
clean the device and the tools, as well as their
internal components, do not use aggressive
substances or abrasive materials.
dry before you remove them.
Cleaning the device
sure they are totally dry before using them again.
Do not use any aggressive or abrasive detergent and
don't use hard brushes.
Cleaning of the dust container (E)
1. Extract the dust container (2) by pressing the
dust container release button (15).
2. Turn the upper part of the dust container anti-
clockwise to access the dust container.
3. Open the lid and empty the dust container.
4.
tainer under running water.
5.
long as all its components are totally dry.
6.
sure the symbol
.
7. Please re-position the dust container in its hou-
then in the lower part until you hear the click of
"closing complete".
Filters cleaning (F)
1. Extract the dust container (2) by pressing the
dust container release button (15).
2.
3.
(14).
4.
5.
6.
7.
der to insert it correctly in its space on the dust
container.
8. Please re-position the dust container in its hou-
then in the lower part until you hear the click of
"closing complete".
is in line with the symbol.
-
-
-
-