Advertisement
Available languages
Available languages
DEVICE DESCRIPTION
1.
Brush
2.
Dust container
3.
Power electronic regulator
4.
Steam selection button
5.
Tank
6.
Tank lid
7.
Pipe housing handle
8.
Pipe handle
9.
Handle
10. Top cable-winder support
11. Bottom cable-winder support
12. Power cable
13. Filter grid
14. Filters
15. Dust container release button
16. Steam cleaning tool
17. Carpets tool
18. Filling bottle
19. Cloth for everyday cleaning
20. Wall support
INTRODUCTION
Welcome to Floor Care by Hotpoint-Ariston.
We would like to thank you for purchasing this
device. Please register it on www.hotpoint.eu
support.
Before you start using this device, you
should carefully read these instructions; ple-
ase store them for future reference.
GENERAL SAFETY CONDITIONS
The security of your device is in line with technical
for other aims than those for which it was produced.
An improper use could lead to injuries to people and/
or damages to things.
The voltage of your system must correspond
to the voltage of the device (220-240 V). Any
connection
mistakes
damage to the device, thus voiding its warranty.
Please do not pull or transport the device by
pulling its power cable.
socket by taking the plug. Please wind the cable.
Never pull out the plug by pulling the power
cable.
Do not bend the power cable. Keep it far away
from sharp edges or corners to avoid damaging
it.
can
cause
irreparable
Never leave and never use the device on or
other heat sources.
please immediately unplu
BURNS DANGER.
Please pay attention while using the device. The
emitted steam is extremely hot.
risk slipping and falling.
Do not walk on surfaces which have just been
cleaned before they are dry.
Do not force the plug into the wall socket.
Do not use extension leads or cables with an
unsuitable length.
Please only use tools recommended by the
producer
The following uses are forbidden:
-
-
on surfaces which can get in touch with
-
-
without the cleaning cloth
-
in the open air.
A)
Never immerse the device in water or other
liquids.
B)
Don't handle the plug or other devices with
we hands or with bare feet.
C)
In order to avoid overloads to the electric
same wall socket.
D)
Do not try to unmount or repair this devi-
ce. A wrong assembly operation can cause
danger of electric shock or damages to pe-
ople when using the device.
E)
Never aim the device towards electric
respect the minimum distance from wall
sockets or similar devices installed on the
Please always keep a well-lit working area.
Please make sure there are no body parts stuck
under the device.
Please pay attention especially when the device
it en
-
17
Advertisement
