Singer SISS2280 User Manual page 6

HOW TO FILL WATER
The appliance has an electronic system to monitoring the water level. When the water
level is lower than the pre-set value, the
water is re-filled.
1. Disconnect the power cord from mains supply outlet.
2. Press the water tank release button
and pull out the water tank, see Fig 1
3. Open the water inlet cover
4. Fill water through the water inlet hole
up to MAX level
marked on the side of water tank
5. Close the water inlet cover
6. Replace the water tank in its place.
FIRST TIME IRONING
1. Remove any protective films or sticker from the soleplate and the cabinet, if any.
2. Unwind and straighten the power cord and supply cord.
3. Fill the water tank with tap water. (See HOW TO FILL WATER)
4. Connect the appliance to a suitable mains supply outlet.
5. "Beep" sound would be heard and the LCD would display all logos for a Second
then turn off.
6. Press the power On/Off button
7. The medium steam level (
will display in the LCD with a beep sound.
8. The will blink to indicate; the steam station is heating up or cooling down for
the steam ironing.
9. Select the Max steam level (
a beep sound would be heard.
10. Turn the Temperature Dial on the Iron unit in clockwise direction to Maximum
position, the Pilot Light will glow.
11. The steam station pressure will increase step by step as
12. The will disappear from the LCD, when the steam station reached the
appropriate heat
13. Wait until the LCD display the
high pressure.
14. Pilot Light goes off when the required temperature for the iron unit is reached.
15. The appliance is ready to use.
16. Depress the Steam Button for 1 minute to clean the steam generating system.
17. Begin first time ironing with an old towel
icon will blink with beep sound until the
Fig 1
) and medium hard water level (
) indicator by press the "+" LCD control button,
icon, its mean the steam station reached the
Page 6 of 12
) indicators