HOMCOM A90-001V70 Assembly Instruction Manual page 12

Common malfunctions and solutions
Malfunctions
Treadmill
does
not work
Running belt dose
not
move
smoothly
E01
E02
E03
E05
E06
E07
Cause
Unplug Connect the power cord
Safety lock is Put the emergency stop device
not in the right on the right
place place in control panel
Single wire or
power Check signal wire
supply broken
Switch off Switch on
Not enough
Lubricate with silicone oil
lubricating
Adjust the intensity of the
Running belt is
running belt
too tight
Control panel
Check whether the
does not
communicating wire is broken or
work
unplug
Over voltage
Turn off the product and turn on
protection
again the product will be ok.
Over current Turn off the product and turn on
protection again the product will be ok.
Over loading
Overloaded
protection
1. The main cable interface is
loose;
Communication
2. The electronic watch is
error
broken;
3. The controller is damaged;
1. The safety switch is not
installed;
2. The induction wire of the
Safety lock
safety switch is broken;
disconnected
3. The safety switch interface of
the electronic meter is
damaged;
１１
Solution