Casio WK-3000 User Manual page 73

4
Use the [ ] and [ ] CURSOR buttons to move to
the location in track where the note or parameter
you want to change is located.
Note editing example
Velocity
N o t e C 4
5
Make any changes in the value that you want.
• The actual procedures you use to change a parameter
depend on the type of data it contains. See "Editing
Techniques and Display Contents" on this page for
details.
6
Repeat steps 4 and 5 to edit other parameters.
7
Press the START/STOP button to end editing when
you are finished.
NOTE
• The only parameters that can be editted for Tracks 2
through 6 are notes and tone numbers.
• In the case of real-time recording, you later can change
tone numbers you specified while recording to Tracks 1
through 6 is in progress.
• You can only change tone numbers that were originally
set for Tracks 2 through 6 using step recording.
• In the case of real-time recording, you later can change
rhythm numbers you specified while recording to Track
1 is in progress.
• You can only change rhythm numbers that were originally
set for Track 1 using step recording.
• You cannot use the edit procedure to add more data to
a recording.
• You cannot move portions of a recording to a different
location within the recording.
• Note lengths cannot be changed.
735A-E-073A
WK3100_e_61-73.p65
Pitch
Parameter being
edited
71
Song Memory Function
Editing Techniques and Display
Contents
The following describes the editing techniques you can use
to change the various parameters stored in memory.
To change the key pressure (velocity) of a note
Use the number buttons or [+] and [–] to adjust the key
pressure.
N o t e G 4
To change the pitch of a note
Input a new note on the keyboard or use [+] and [–] buttons
to change the pitch of a note. The pitch you specify here is
reflected in the keyboard and the notes shown in the staff on
the display.
N o t e G 4
IMPORTANT!
• Whenever editing memory contents, never change a
note so it is identical to the note before or after it. Doing
so may alter the length of the changed note and the
note before or after it. Should this happen, you will have
to re-record the entire track.
To change a chord
Use the chord fingering method selected by the MODE button
(Fingered, CASIO Chord, etc.) to input a chord.
C h o r d
To change a tone number
Use the number buttons or [+] and [–] buttons to change a
tone number.
G r a n d P n o
04.3.26, 0:11 PM
E-71