Important Safety And Installation Instructions; Product Introduction - emaux E-Lumen X Series User Manual

TOP13-VL / TOP13-VS
1-1
1-2
6
Key No. Part No.
112010111 Screw M3*18.5(316)
1-1
1-2 440547998 15 LEDs Panel 13W Color
1-3 440647771 Fastener Left
1-4 440647772 Fastener Right
M3*8 screw 316
1-5 112362743
1-6 440517766 Face Plate
1 E042701 15 LEDs Panel Suite 13W Color for TOP13-VL/VS(Composition of 1-1,1-2,1-3,1-4,1-5,1-6)
E042702 Retro-fit Connector(For TOPAZ, with cable 2.5m)
2
105107997 Cable 2.5m(For TOPAZ)
TOP13-VL/VS Water Joint Fittings for Cable
3 E042703
02021091 Rubber Ring
4
440017769 Nut
5
440087767 Lights Niche TOP13-VL
6
440087768 Lights Niche TOP13-VS
Joint for wire & pipe Suite TOPAZ
E042704
7
P14 SPARE PART LIST
1-3
1-4
1-5
1-6
1-5
2
3
4
5
6
7
Description QTY
1
1
1
1
6
1
1
1
2
1
1
1
1
1
1

1. IMPORTANT SAFETY AND INSTALLATION INSTRUCTIONS

Please read the manual carefully before commencing installation. This manual contains
important information about the correct installation and operation of TOPAZ lights.
1. Only qualified electrician is allowed to carry out the installation of this product.
2. Avoid direct contact with electrical power.
3. Respect all regulations in effect for preventing accidents.
4. All units are required to be disconnected from the main electricity before any operation of
maintenance.
5. For safe and proper installation, ensure that those parts supplied with the produce are used.
6. Never handle with wet hands and feet.
7. This unit is design for use only when fully submerged in fresh water, connecting with a safety
transformer
8. This product should be installed according to your local electrical installation ordinances and
regulations.
9. Due to the corrosive nature of unbalanced pool chemicals, please keep you pool water is acid-
base balanced prior to installation, and ensure the longevity of these lights.
10. If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively
replaced by the manufacturer or his service agent or a similar qualified person in order to avoid
a hazard.
11. Check that there is enough cable behind light to allow for servicing above water, preferably at
ground-level pool-side.
12. Never operate this Underwater Light for more than 1 minute unless it is totally submerged in
water.
13. You lights require cleaning at any time, be sure to a mild detergent or other ways that don't
damage to the lights.
14. Be sure power is off before installing or removing LED plate. Allow LED plate to cool before
replacing.
15. Maximum Depth for Light installation at 1.2 meter.
16. Maximum Water Temperature Range for light operation 0-25°C
For non replacable lightsources: "The light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire shall be replaced".
For operation only with safety isolating transformer conforming with AS/NZS 61558 series.

2. PRODUCT INTRODUCTION

The wall mount retrofit swimming pool underwater light is designed to latest LED lighting
technology. There are two 30 second self-determine operating mode which is fully compatible to
50Hz or 60Hz input voltage frequency. When the lights use the same power source, they will be
self-synchronize during color change mode without color alignment reset. The light include RGB
color LED, individual warm and cool white, 5 different LED color in total. The two mode can't be
applied at the same time.
IMPORTANT SAFETY AND INSTALLATION INSTRUCTIONS P3