Settings For Rs485 Terminals Use - Sanyo SRT-2400 Instruction Manual

SETTINGS FOR RS485 TERMINALS USE

If the VCR is going to be controlled trough a connection to
the RS485 terminals, be sure to first make the settings
below.
NOTES:
Can only be used with the optional RS-485 board.
When using the optional RS-485 board, the VCR can
be controlled from a special controller.
1
Press the MENU button until the (SET UP 6) menu is
displayed.
° The "ADDRESS" setting is flashing.
@@@@@@@<SET@UP@6>
*RS485
@@ADDRESS@@@@@@@000
@@TERMINATE@@@@@N
@@DATA@SPEED@@@@19200
@@STATUS@INFO@@@Y
@@ALARM@INFO@@@@Y
2
Press the l (or j) button to set the VCR address,
then press the ] button.
NOTES:
The address can be set between 000 and 127.
Keep the button pressed and the setting will
change rapidly.
3
Press the l (or j) button to set the termination, then
press the ] button.
N . . . . . . . . . . Not terminated
Y . . . . . . . . . . Terminated
4
Press the l (or j) button to set the data transfer
speed, then press the ] button.
19200 2400 4800 9600
38
5
Press the l (or j) button to set the "STATUS INFO"
setting, then press the ] button.
Y . . . . . . . . . . . The VCR status information (state
information and warning state) are
output at the RS485 terminal.
N. . . . . . . . . . . The state information is not output
at the RS485 terminal. However,
the warning state is output at the
RS485 terminal.
6
Press the l (or j) button to set the "ALARM INFO"
setting.
Y . . . . . . . . . . . The VCR alarm information
(alarm recording start and stop)
and video loss information are
output at the RS485 terminal.
N. . . . . . . . . . . The VCR alarm information
(alarm recording start and stop)
and video loss information are not
output at the RS485 terminal.
NOTE:
The video loss information output (sent) will depend
on the settings for "VIDEO LOSS" in the (SET UP
4) menu.
7
Press the PAUSE/SEARCH button to save the
settings.
English