Sanyo SRT-2400 Instruction Manual page 31

PROGRAM TIMER RECORDING
NOTES:
During timer recording or timer recording stand-by, all
the buttons on the VCR, except the TIMER button and
the buttons to set/cancel the security lock (see page
35), are disabled.
If the power fails, the recording will be interrupted.
When the power is restored, the recording will resume if
the stop time has not yet been reached, and "P" will be
displayed on the digital display. The VCR internal
battery is completely recharged after the VCR has been
connected to a live outlet for 48 hours, and it will
maintain all the VCR settings memory for up to 30 days.
Set the timer recordings so that the recording times do
not overlap. If they do, the one with the earliest
recording start time will have priority. (See chart below.)
7:00PM 8:00PM
Program 1
Program 2
Program 3
These portions will
not be recorded
To set two or more timer recordings for a same day of
the week, press the * (or ]) button, until the day of the
week for the second recording is flashing, then press
the l (or j) button, to set the desired day of the week.
If no timer recording is set or a cassette without
erasure-prevention tab is loaded, when the TIMER
button is pressed the timer recording indicator "n" will
start flashing and a buzzer will be heard.
If "OFF" is displayed on the digital display, timer
recording is not possible in order to prevent the
recorded tape to be recorded over.
9:00PM 10:00PM
30
English