Table of Contents
Advertisement
Exposure button
Preparing for exposure
Press the exposure button down to the first pressure point and hold it for
approximately 0.5 s to 2 s.
The X-ray tube is prepared for performing an exposure.
Starting the exposure
Before starting the exposure:
1. Check if the exposure settings displayed on the console are suitable for the
exposure.
2. Check the Ready for Exposure status.
Press the exposure button down fully and keep it pressed until the exposure
has ended.
The radiation indicator on the control console lights up and a signal sounds to
indicate the exposure.
DR Generator Sync Box, DR Retrofit Solution | Introduction | 17
Note: Letting the exposure button go ends the exposure
immediately and the exposure can be underexposed.
0319D EN 20191031 1011
Advertisement
Table of Contents
