Advertisement
Hardware Installation Guide for Polycom SoundStructure TEL1 and TEL2
To install a plug-in card, follow these steps:
1 If plugged in, unplug the AC power cord from the SoundStructure device.
2 Remove the blank plate and screws from the expansion slot (see below).
3 Insert the plug-in card into the slotted rails and push until it is tight into the slot.
4 Tighten the thumbscrews on the rear-panel of the plug-in card.
5 If no further installation steps are required, plug in the AC power cable; otherwise, continue with the
remainder of the installation steps described in the SoundStructure Hardware Installation manual
prior to applying power.
When the system boots up, the telephony card will be discovered automatically.
Polycom, Inc.
LAN
C-LINK2
IN
LAN
C-LINK2
PHONE
LAN
C-LINK2
IN
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232
OBAM
IR
OUT
12V
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232
OBAM
IR
IN
OUT
12V
LINE
PIN 2: TXD
PIN 3: RXD
PIN 5: GROUND
PIN 7: CTS
PIN 8: RTS
RS-232
OBAM
IR
OUT
12V
5
Advertisement
