HermanMiller Canvas Office Landscape Manual page 7

5
Three-sided COH Connector Cover
Connector
Top Cap
C
F
1. Attach Connector Tube (K) to frame
using Washer (M) and Screw (L).
Tighten screw (L).
2. Install tiles on frames.
3. Install COH Trim Block Clips (G)
on Trim Block (F) only on sides
where frame top caps mate.
4. Install COH 3-sided Trim Block (F)
w/Trim Block Clips (G) on wire
channel.
5. Slide 3-sided Connector Cover (C)
over Trim Block (F) & Connector
Tube (K).
Z
© 2017 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z and Canvas Office Landscape are among the registered trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.
Frame Top Cap
Light Seal
Flush
at Top
K
Frame Top Cap
L
M
6. Slide lower frame Top Caps over Trim
Block Clips (G). Frame top Caps must
be snapped to wire channel and slid
over (G).
7. Insert Connector Top Cap into Frame Top
Caps.
8. Attach Top Caps to Frames making sure
Connector Top Cap fits into Connector
Cover (C).
G
Part no. 1b2hhp rev J.
7