Appliance Installation - Fidelis Deception Decoy Server FDH-1000-C Quick Start Manual

5. Decoy Server – Logical Network Configuration
Configure the Admin and iLO according to your network configuration. See the table below as a sample.
Appendix A has a worksheet you can use.
Note: The logical configuration for decoys is done as part of the decoys creation process.
Sample Configuration for Decoy Server
Network Setting
Interface
Hostname (FQDN)
Static IP Address
Subnet Mask
Gateway
Proxy Server
DNS Servers
NTP Servers
Time Zone

6. Appliance Installation

Rack Installation
Install each appliance in an enclosure/location that has necessary power and cooling. Ensure that the
installation environment is within the operating temperature of the appliance. See
appliance operating temperature requirements.
Power
Connect power cables to the power supplies in the back of the appliance. See
power requirements.
Network Cabling
Using the connectors and cables described in sections 3 and 4, begin to connect the appliances to the
networks. Cable the sensor appliance(s) to the switches:
1. Connect the Admin (eth0) port to the ADMIN switch port.
2. Optionally, connect the iLO port to the ADMIN (or iLO) switch port.
.
Copyright © 2022 Fidelis Cybersecurity
Admin
10.1.2.3
255.255.255.0
10.1.2.1
®
, Inc. All rights reserved
Assignments
DecoyServer1.myorg.int
10.2.3.4
255.255.255.0
10.2.3.1
10.5.6.7
8.8.4.4, 8.8.8.8
0.pool1.ntp.org
UTC (+0)
Appendix B
Appendix B
7
iLO
for
for appliance
www.fidelissecurity.com