Appliance Installation; Appliance Network Configuration - Fidelis CommandPost+ Quick Start Manual

6. Appliance Installation

Rack Installation
Install each appliance in an location with necessary power and cooling.
Power
Connect power cables to the power supplies in the back of the appliance.
Network Cabling
Using the connectors and cables described in sections 3 and 4, begin to connect the appliances to
the networks.
Cable the CommandPost+ appliance(s) to the switches:
1. Connect Admin (eth0) port to the ADMIN switch port.
2. Connect the iLO port to the ADMIN (or ILO) switch port (optional).

7. Appliance Network Configuration

1. Power on the Appliance(s).
2. Connect to the component CLI using one of the following methods:
−
Via SSH: Directly attach an Ethernet
cable from a client system such as a
laptop to the Admin/eth0 port on the
appliance. The default IP address is
192.168.42.11/24. Assign a static IP
from the same subnet to the network
interface on the client system and
connect to the appliance using SSH.
−
Via KVM Console: Connect a keyboard
and monitor to the appliance.
For Fidelis Network appliances version 8.3.4
or later, the screen on the right is displayed:
©Fidelis Cybersecurity
Fidelis Network™ CommandPost Appliances
5
QUICK START GUIDE
www.fidelissecurity.com