Setting Up The Refrigerator; Removing The Refrigerator Doors - Samsung RFG237 Series User Manual

sEttinG uP tHE REFRiGERatoR

Now that you have your new refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the refrigerator in an appropriate location with reasonable clearance between the walls and the
refrigerator.
Refer to installation instructions in this manual. (page 9, Selecting the best location for the refrigerator)
2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The freezer will get slightly
chilled and the motor will run smoothly.
4. After powering the refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the refrigerator after the temperature is sufficiently low.
Check the accessories listed below.
Water filter
Required Tools(Not provided)
Philips screwdriver(+) Flat-blade screwdriver(-)

REMoVinG tHE REFRiGERatoR DooRs

Some installations require door removal to transport the refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer, make sure you read
following items.
Disconnect power to the refrigerator before removing the door or drawer.
WARNING
• Be careful not to drop, damage or scratch the door/drawer while removing them.
• Be careful not to get injured while removing the door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Disassemble the refrigerator doors
Be careful not to drop and scratch the doors while
removing the doors.
WARNING
Disassemble the refrigerator doors
1. With the door opened, remove the hinge top table (
with a flat-blade screwdriver, and close the door.
Remove the 3 screws holding down the top table
( ) and remove it.
2
Hex wrench Fastener
Socket wrench (10mm)
Compression fitting
Pliers
)
1
1
Compression nut
Allen wrench(3/16")
(5mm)
2
Setting Up _9