Using The Solar Monitor - Dometic BUTTNER MT iQ SolarPRO Installation And Operating Manual

Using the solar monitor

8 Using the solar monitor
8.1 Switching the solar monitor on
I
NOTE
• After 30 seconds without pressing the
monitor dims.
• After 120 minutes without any operation the display of the solar monitor automati-
cally switches to the standby mode.
In the standby mode the measurement continues, indicated by a slow flashing
power symbol in the middle of the display.
➤ Press the
button once to switch on the solar monitor.
✔ The last measured value called up is shown on the display.
14
button the LED back light of the solar
MT iQ SolarPRO
EN