Table of Contents
Advertisement
Available languages
Available languages
NOTICE Risk of overheating
Ensure that there is at least 2 cm space
around the monitor.
Figure
on page 1
Observe the following installation instructions:
•
Select an installation location that provides an
unobstructed view of the monitor.
•
The installation location should be flat.
•
Ensure that there is sufficient space under-
neath the installation location to attach the
washers and nuts.
•
If necessary, use reinforcement (larger wash-
ers or plates).
1.
Place the monitor on the monitor bracket.
Figure
2. Position the monitor with the attached monitor
bracket provisionally.
3. Mark the outlines of the monitor bracket on the
dashboard.
4. Remove the monitor from the monitor bracket.
6.1.2
Laying cables
NOTE If possible, use original ducts
for laying the connection cable or oth-
er suitable options, such as ventilation
grilles. If there are no existing ducts, a
hole needs to be drilled into the dash-
board.
1.
If necessary, drill a hole with a diameter of 17 mm
through the dashboard near the desired installa-
tion location.
2. Pull the monitor cable through the existing duct
or the drill hole.
6.1.3
Mounting the monitor
1.
Place the monitor bracket within the marked out-
lines.
8
on page 2
2. Mark the drilling points.
3. Remove the monitor bracket.
4. Drill the holes, with a diameter of 2 mm, at each
of the markings.
5. Remove the foil from under the monitor bracket
(Figure , A).
Figure
6. Replace the monitor bracket to the marked out-
lines.
7.
Screw the monitor bracket to the dashboard us-
ing 4 x 20 mm self-tapping screws (Figure ,
B).
8. Place the monitor on the monitor bracket.
9.
Secure the monitor with the knurled nuts.
6.1.4
Connecting the monitor
electrically
NOTICE Damage hazard
•
Only connect the monitor to the
correct voltage.
•
Install the cables and connec-
tions as specified to avoid mal-
function, component failure, and
to ensure continuous and prop-
er operation of the connected
accessories.
•
Ensure that the cables have
sufficient distance to vehicle
parts that can get hot (lighting,
heaters, fans, etc.).
Figure
on page 4
No. Description
1
Monitor
2
Monitor cable plug
3
Connection cable socket (diameter 21 mm)
4
Connection cable
5
CAM1 socket
6
CAM2 socket
on page 3
Advertisement
Table of Contents
