Commissioning
Attention!
Vacuuming hot ash is prohibited. The temperature of the suction material must not exceed
40 ℃.
•
Make sure that all preparatory measures have been completed.
•
Also make sure that the switch of the vacuum cleaner is set to "O" (Off) before connecting the
appliance to the mains.
•
Next, insert the plug of the power cord into the socket and set the switch to "I" (On).
•
After finishing work and before carrying out maintenance work, switch the vacuum cleaner off
and disconnect the plug.
Note!
When using the vacuum cleaner as a blower, make sure that the container has been emptied and
the filter either cleaned or replaced with a new one. Otherwise, any dirt remaining in the container may
be blown out through the outlet opening.
Maintenance
Note!
Pull out the plug before carrying out maintenance work!
•
After each use of the vacuum cleaner, the container, lid seal, and air filter must be checked as
described in these instructions.
•
The ash vacuum cleaner is cleaned from the outside with compressed air at a maximum pres-
sure of 3 bar. During this process, particular attention must be paid to the ventilation openings
for the supply and exhaust air. If necessary, clean them with compressed air at a maximum of
3 bar. Do not use sharp metal objects to clean the ventilation openings.
•
When cleaning the ash vacuum cleaner, do not immerse it in water.
•
Before each use, the vacuum cleaner hose must be checked for damage. Never use a damaged
hose. Any major soiling of the housing should be removed with a soft cloth.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 63122
Page 7
02
2022-1