I want to start Anynet+.
I want to exit Anynet+.
The message "Connecting to
Anynet+ device..." appears on
The Anynet+ device does not
Check if the Anynet+ device is properly connected to the TV and
check if the
Press the TOOLS button to display the Anynet+ menu and select a
menu you want.
in the Anynet+ menu.
Press the SOURCE button on the TV remote control and select a
non- Anynet+ device.
and PRE-CH to change the TV mode. (Note that
the channel button operates only when a tuner-embedded Anynet+
device is not connected.)
You cannot use the remote control when you are configuring
Anynet+ or switching to a view mode.
Use the remote control after the TV has completed Anynet+
configuration or has finished switching to Anynet+.
You cannot use the play function when
is set to
in the Anynet+
Plug & Play
(initial setup) is