Do not operate the equipment with the door open due to microwave
Ÿ
energy exposure.
Do not allow food residue or other debris to accumulate on the surface of
Ÿ
the door and hinge to avoid damaging the equipment.
Foods with skin, bark or membrane, such as tomato, potato, sausage,
Ÿ
must be perforated with a fork as they may explode.
Fully sealed packages should not be heated in the oven as they can
Ÿ
explode.
Do not cover or block any air vents on unit.
Ÿ
Do not use the equipment outdoors or without coverage.
Ÿ
Do not use this product near water such as near the kitchen sink, in a wet
Ÿ
basement, or near a swimming pool.
Do not use a water jet for cleaning the unit. Please see cleaning
Ÿ
instructions for proper cleaning.
When cleaning the oven surfaces use only non-abrasive products applied
Ÿ
with a nylon sponge or soft cloth
sure the correct cleaning product is being used.
To reduce the risk of fire in the oven cavity: remove wires used to seal
Ÿ
paper or plastic bags that will be into the oven.
Carefully monitor the equipment when materials such as paper, plastic,
Ÿ
and other combustible materials are placed inside the oven for easy
cooking.
Remove all contents located inside the oven cavity.
Ÿ
If the product catches fire inside the cook cavity, close the door
Ÿ
immediately and turn the unit off or unplug it. The power can also be
turned off at the circuit breaker.
Always wear thermal gloves or use holders or tongs to remove the food
Ÿ
from inside the equipment to avoid burns.
(page 70) Note: Consult Prática to make
.
09
Need help?
Do you have a question about the Copa Express and is the answer not in the manual?
Questions and answers
the machine would not turn off last night so we unplugged....now it will not turn on..we have power to the unit....
The Pratica Copa Express may not turn on immediately after being unplugged because, when enabling the oven circuit breaker, it is necessary to wait ten (10) seconds before turning it on.
This answer is automatically generated
Worked fine this morning, now gives “chamber system failure “ on start up