General Instructions - Pratica Copa Express Installation And Operation Manual

INSTALLATION INSTRUCTIONS
Note: The equipment has a connector for interconnect it with
other equipment. This connector is intended to keep several
devices with the same electrical potential. Not necessarily the
grounding of a local connection. This connector on the back of
the device is identified by the symbol on the right:
Maximum
Distance
6
(1.8m)
Air Inlet

GENERAL INSTRUCTIONS

The oven must be installed on a surface or counter that supports its
Ÿ
weight of approximately 179lb (79 Kg).
Do not obstruct the air inlets and outlets at the oven bottom.
Ÿ
The oven must not be positioned near stoves, deep fryers, hot plates and
Ÿ
other equipment that releases fat, fumes and heat. The ventilation,
electrical panel and motor vents must be far from these heat sources to
prevent damage to the electrical system of the equipment.
The oven must be installed in a leveled and well-ventilated area.
Ÿ
The installation of the equipment in a non-suitable place can result in the
Ÿ
warranty loss.
Use of pressure cables to prevent movement
Ÿ
of the power cable.
In case the oven voltage is 380 volts, a
Ÿ
neutral cable (independent of the ground)
must be available.
Ensure that the electrical characteristics of
Ÿ
the power grid are in accordance with the
technical specifications located on the
Circuit
identification tag label located on front
Breaker
bottom cover of the unit. The power grid is a
customer's responsibility.
This unit must be properly grounded to avoid
Ÿ
electrical shock .
The circuit braker should be located no more
Ÿ
than 70,8in / 6ft / 1.8m away from the unit.
21