Before First Use - Prinetti IA4547 Instruction Manual

Before First Use

Remove all the parts from the packaging materials and thoroughly read the user
manual before using this appliance for the first time. Ensure all parts indicated on
the parts diagram listed have been included in the gift box. Plastic wrapping can
be a suffocation hazard for babies and young children so ensure all packaging
materials are kept out of reach of children.
• We recommend you keep the original packaging for storing the Outdoor
Heater when not in use.
• Unwind the cord to its full length and inspect the cord and plug for damage.
• Do not use the Outdoor Heater if any parts are damaged. In case of damage,
phone the after sales support line on 1300 777 137.
• Proper mounting technique and clearances must be followed while installing
the Outdoor Heater.
• The Outdoor Heater is protected from low pressure water/rain from any
direction therefore should be located under a covered area to be protected
from high pressure water/heavy rains. If the Outdoor Heater has been
exposed to high water pressure or extreme wetness be sure to dry the
Outdoor Heater before using it again. The power outlet and plug need to
always be undercover and fully protected from all elements as the power
outlet and plug cannot get wet.
Approximate Heating Area
Infrared Radiant Heaters produce radiant heat which heats objects rather than
air. Therefore, it is imperative that objects to be heated (i.e., people), are within the
direct radiant footprint of the heater.
The below diagram shows the approximate heating area, based on an outdoor
enclosed environment, with direct overhead mounting. The radiant footprint is
reduced in angled and wall mounted installations.
Outdoor spot heating
08 AFTER SALES SUPPORT AU 1300 777 137 NZ 0800 824 556 service@unclebills.com.au