Table of Contents
Advertisement
Assembly
Unpack the Outdoor Heater making sure that all the parts are present and that the
heater is free from any packing material.
Do not connect the heater to the power supply until all the assembly is complete.
However, the Outdoor Heater needs to be installed within reach of a power supply.
Be sure the cord length is within reach of the power supply before installing. Please
read all instructions before installing the Outdoor Heater.
Do not connect the Outdoor Heater to the power supply if any of the components
or the power cable is damaged in any way.
To assemble the Outdoor Heater, please
follow the following steps:
1. Connect the fixed mounting bracket to the
sliding bracket (see Fig. 1). Repeat for other
fixed mounting bracket and sliding bracket
provided.
2. Lay the Outdoor Heater on a flat surface
with back of the Outdoor Heater facing
up, corded plug entry on the right and
adequate cushion provided in between
the surface and Outdoor Heater so no
damage is caused to front radiating
surface. Install sliding bracket with fixed
mounting bracket as below (see Fig. 2).
Fig. 2
NOTE: Mark the position of the two sliding brackets, using the minimum
recommended bracket spacing of 710mm to determine the correct location.
NOTE: The Outdoor Heater comes bubble wrapped. To avoid any damage to the
Outdoor Heater while laying it down on a flat surface, the bubble wrap with the bubble
side up can be placed in between the flat surface and front radiating surface.
AFTER SALES SUPPORT AU
1300 777 137 NZ
0800 824 556
Fig. 1
service@unclebills.com.au
11
Advertisement
Table of Contents
