Fm Radio Operation - Jensen JEP-175 User Manual

USB POWER
The unit has a DC IN (MICRO USB) JACK (#11) on the front of the unit.
1. Use the micro USB plug side of a 5V DC, 1A output AC adaptor (not included), and
connect it to the DC IN (MICRO USB) JACK (#11) on the front of the unit.
2. Ensure plug the AC adaptor into an 120V AC, 60Hz household outlet.
Note: The USB power adaptor (not included) described above is the same type commonly
used with smartphones. A USB to micro USB cord is also required for charging the unit
via the micro USB jack located on the front of the unit.
SOLAR POWER
1. A 3.7V rechargeable Li-ion Battery is installed in the unit.
2. Put the unit in direct sunlight, making sure the SOLAR PANEL (#14) of the unit is facing
towards the sun. If the sunlight is strong enough, the red LED of the POWER INDICATOR
(#10) will light indicating the unit is charging when the unit Is off. More power is generated
the longer you leave the unit in direct sunlight.
Note: If the battery is completely drained, it may require very long exposure to direct sunlight
in order to charge the battery using the solar panel. You should use the USB POWER
if you need to use the radio immediately.
Listening to the radio:
1. Switch the ON/OFF SWITCH (#9) to on position to turn on the unit. The multi colors LED
accent lights in speaker will turn on and flash.
2. Repeatedly tap the MODE BUTTON (#2), you will step through the different modes
available: Bluetooth ->
*Note: When stepping through the modes, USB and AUX LINE-IN will be skipped unless a
USB flash drive is inserted and an Auxiliary line-in cord is plugged in.
3. Tap the MODE BUTTON (#2) repeatedly to select FM radio mode. The blue LED of the
POWER INDICATOR (#10) will light and flash. A voice "FM RADIO" is to confirm the unit
switch to FM RADIO mode.
4. Press and hold the PLAY/PAUSE
frequency to the highest frequency and will automatically save the stations found. The
POWER INDICATOR (#10) flashes fast during the unit is scanning.
5. The unit will start to play the first station saved after scanned the whole FM band.
6. Tap the + / - BUTTONS (#3/#5) to adjust the volume to obtain the desired volume level.
7. Press and hold the + / - BUTTONS (#3/#5) to select next or previous preset station.
8. Tap the PLAY/PAUSE
POWER INDICATOR (#10) will light steadily. Tap The PLAY/PAUSE
again to turn off the mute function. The blue LED of the POWER INDICATOR (#10) will
flash again.
9. Switch the ON/OFF SWITCH (#9) to off position to turn off the unit.
TIPS FOR BEST RADIO RECEPTION
If FM reception is weak, fully extend the TELESCOPIC ANTENNA (#7) and vary the location
of the unit until you find the strongest signal.

FM RADIO OPERATION

FM Radio -> USB* -> AUX LINE-IN*
BUTTON
BUTTON (#4) to mute the speaker. The blue LED of the
E-6
(#4). The unit will scan from the lowest
BUTTON (#4)