Swing; Swing Setup; Swing Operation - Samsung SCC-3000 User Manual

PTZ Mode

(3) SWING

■ This menu is for setting the camera to alternate between two assigned locations horizontally (pan) or vertically (tilt).
Setting the SWING SETUP menu by controllers is only possible in the SPD series. In case of products by other
manufacturers, the setting has to be done by the OSD menu of the camera. See the camera manual for more
information.

(3-1) SWING Setup

① At the [PTZ SETUP 1 ▶] menu, press the 2 button (see p.15).
② Press the 1 or 2 button to select a horizontal (pan) or vertical (tilt) cycle.
③ Set starting point, ending point, movement speed, and stop time.
- I▶/▶▶ button: Moves between items.
- 1ST : Starting point. Can be set for Preset 1 ~ 64.
- 2ND : Ending point. Can be set for Preset 1 ~ 64.
- SPEED : Movement speed. Can be set for 1 ~ 64 (see p.35).
- STOP : Stop time at the starting point and ending point.
Can be set to 1 ~ 99 (seconds).
④ Press the ENTER button to finish the setup (takes 2 or 3 seconds to
finish).
▤ The Swing function cannot be set if an unassigned number or a
number outside the selectable range is entered.
▤ Over 2 PRESET locations have to be set before setting SWING.

(3-2) SWING Operation

① At the initial screen, press the Swing button.
② Press the 1 and 2 buttons to perform the Swing function.
- 1 button: Performs the horizontal cycle (pan).
- 2 button: Performs the vertical cycle (tilt).
▤ Move the joystick or press a controller button during the Swing
operation to stop the operation.
▤ AUTO-PAN is performed automatically when the SWING button of
PANASONIC(WV-CS854A) and SAMSUNG ELECTRONICS
(SCC-641/643) cameras is pressed.
SWING SETUP SWING SETUP
CAM ID: CAM ID: 5 5
1:PAN SET 1:PAN SET 2:TILT SET 2:TILT SET
Press Numeric Key Press Numeric Key
SWING SETUP
IST 2ND SPEED
00 00 00
Enter:Swing Set
PTZ CONTROL SYSTEM
CAM ID: 5
1:PAN 2:TILT
Press Numeric
SPD SPD
STOP
00
SPD
Key
《17》