Table of Contents
Advertisement
INSTALLATION MANUAL TX80 SKYGLASS
1. INTRODUCTION
This document describes the installation and parameterization of the taximeter
TAXITRONIC TX80 SKYGLASS.
2. INSTALACIÓN SAM
To introduce SAM card the device must be opened, then introduce SAM card in the
skyglass groove as there is shown on the plane
To configure the SAM card, the toolkit manual (SIM/SAM configuration section)
indications must be followed. This process must be done after the installation has been
completed in the vehicle.
3. MOUNTING
3.1. MOUNTING AND LOCATION OF TX80
The device will arrive sealed. It is necessary to open it to proceed to the connection All
TC60 connectors are inside the unit, covered by a sealable cover.
The tools necessary for the installation are:
•
Screwdriver with head format Z1
Al other devices are interconnected with TX80. So it can't be sealed until the whole
installation process is finished.
Inst TX80_Skyglass_003_en.doc
INTERFACOM, S.A.U.
3
Advertisement
Table of Contents
