Table of Contents
Advertisement
INSTALLATION MANUAL TX80 SKYGLASS
RECOMMENDATIONS FOR THE ELECTRICAL INSTALLATION
− Disconnect the positive terminal on the battery until the whole electrical
installation is completed.
− Any manipulation of the taximeter or of the external lights must be done while
the taximeter is disconnected from the power supply
− Always take the positive and negative directly from the battery in order to avoid
false contacts and to obtain a more filtered power supply.
− Always connect the cables to the battery by means of a terminal, never by
winding the wires onto the contact.
− If the cables cross a plate to reach the taximeter they should go through a
protective rubber casing.
− If the cables are too long they should be cut to the required length and not rolled
up under any circumstances.
− If the vehicle has a radio transmitter, separate its installation from that of the
taximeter as far as this is possible.
− If it is possible no element that is connected to the taximeter should be fixed to
the same support as the aerial of the radio.
−
If there is enough length on the connection cable between the TX80 and the
SKYGLASS, the excess should be collected by making an eight and tie that with a
flange, never making a spiral.
5. SEALING
5.1. TX80 SEALING
− Seal Nº1 and 2:
− Seal Nº3: Is the manufacturer sealing, preventing access to the electronic board.
Inst TX80_Skyglass_003_en.doc
Seals the taximeter box, so it seals the electrical installation.
INTERFACOM, S.A.U.
11
Advertisement
Table of Contents
