Important Information About The Boiler Room - Riello RTT 163 Instructions Manual

1.8 Important information about the boiler room

9
The boiler room should be well lit and the light switches
should be located outside the room itself.
9
Place any gas detection devices at a height conforming to
regulations in force.
9
Do not place devices like the water pump, the contactor,
etc., in the boiler room.
9
Repair or replace as soon as possible any electric locks, ca-
bles, etc., that could cause short-circuits.
9
Before carrying out any welding in the boiler room, switch
off the boiler and close the gas valve.
9
The boiler room should not contain any explosive, combus-
tible or inflammable material.
9
The boiler room air should not contain any explosive, com-
bustible or inflammable gas.
9
Children or non-technical persons should not be allowed in
the boiler room, except for the person who is responsible for
it. Keep a copy of the key for the boiler room in a safe place
for emergencies.
9
It is possible to insulate the boiler room against noise and
heat, also the position and the orientation of the boiler are
important for its acoustic insulation.
9
Place the fuel tanks in another room surrounded by walls
and with adequate natural ventilation.
9
Arrange for the creation of a branching of the water supply
line near the boiler and a drainage system for draining the
boiler water.
9
It is strongly recommended not to install extraction systems,
air conditioning systems or other devices in the boiler room
that, as a secondary effect, could cause the so-called "vac-
uum effect" and reduce the draught force of the boiler, with
the main consequence of damaging the burner.
9
Make sure that the boiler room receives sufficient air either
naturally or forced (using an aspirator).
9
To ensure the burner and the boiler work efficiently keep the
boiler room clean and prevent the formation of humidity.
9
The boiler room should have the minimum dimensions
specified.
9
Do not store inflammable material inside the room.
9
Do not touch the supply pipe fitting or other hot parts of the
boiler when it is running.
9
Do not install the boiler on a rubber mat.
9
When using LPG or another liquid fuel, the boiler room, the
fuel, the system components and the hydraulic pipes need
to be in conformity with the parameters established by Eu-
ropean norms and by gas supplying companies. The com-
pany is not responsible for any faults or problems caused by
the inadequate conditions of the boiler room, the hydraulic
pipes and the other components of the system.
9
Follow the instructions of your local gas suppliers.
9