Co2 Bottle Installation - Spring NeoTap Installation And Operation Manual

1. Ensure the Co2 bottle is connected firmly to the regulator and the Co2 tube is
fitted correctly.
2. Slowly turn the dial on the regulator clockwise until the gauge reads 3BAR
(Note: If you want to reduce the pressure you must first turn the dial anticlockwise
and then vent to relieve existing pressure. The gauge will then settle and read
accurately)
3. Turn off the water at the valve and purge any air from the sparkling line by
pressing the sparkling button on the tap for 30 seconds.
Turn the water back on at the valve and the SODA switch at the rear of the unit.
4.
Press the sparkling button on the tap for 15 seconds to allow any excess Co2 to
5.
be dispensed
Operate the sparkling button on the tap 2-3 times for 15seconds each time
6.
(1minute cooldown) until you notice the water is sparkling. Pressure will fluctuate
between 3-4 bar
All Co2 bottles should be upright during use, storage and transit. If the bottle has
been left horizontal, place upright and stand for 60+ minutes before use to allow
contents to settle
+ 6 4 0 9 6 3 6 - 7 0 7 0 | W W W . S P R I N G N Z . C O . N Z | S A L E S @ S P R I N G N Z . C O . N Z
Co2 BOTTLE - INSTALLATION
Co2 Refill Tube
TOP VIEW - Co2 Bottle
Pressure Gauge
Co2 Bottle
Pressure
Regulator
1/4" Pipe