Advertisement
Installation
1
Mounting
The product warranty will be voided if the product is mounted for an exterior door and/or is exposed to elements.
L IMPORTANT: Do not apply power to the unit until you have fully read the instructions and have made the required
adjustments!
Actuators
L NOTE: Actuators are for interior use only!
1a Prepare the cut-out for the unit and fit in the dry wall bracket.
1b Slide in the black vinyl behind the flush enclosure and fit them inside the dry wall bracket.
1c Ensure the two mounting holes on the bracket and the flush enclosure align. Use the 8-32 Phillips screws to completely
tighten in place.
1d Place the electronic board inside the flush enclosure, making sure the screw holes on the electronic board align with the
screw holes inside the flush enclosure. Use the #6 x 3/8" self-tapping screws to tighten the electronic board in place.
1e Place the diffuser insert inside the flush enclosure, making sure the mounting screw holes on the diffuser insert and the
flush enclosure align.
For Push to Open switches
a. Use the 6-32 hex head screws to tighten the diffuser
insert slightly.
b. Fit in the assembled push plate by locating the screws
with the holes on the back plate.
c. Fit the hex key through the hole on the face plate and
completely tighten the 6-32 screws in place.
L Note: Do not overtighten!
Diffuser
6-32 Phillips
screw (2 pcs)
For cleaning purposes, do not expose components to extreme wash-down.
The electric strike is not water-proof.
Flush electronic board
8-32 x 1-1/2"
Phillips screw
(2 pcs)
Electronic board
#6 x 3/8" Phillips
self-tapping screw
Plastic spacer
(For use only on Push to Open)
CAUTION
For Push to Open/Push to Lock combo switch
a. Fit the plastic spacer inside the diffuser insert.
b. Place the combo switch inside the diffuser insert,
making sure the mounting holes on the board and on
the back plate align.
c. Use the 6-32 Phillips screws to tighten in place.
Label
Black vinyl
enclosure
Electronic Board Dip Switch Settings
Enable
(2 pcs)
1
2
3
Dry wall bracket
= Switch Position
Active Color
Idle Color
1
REM/LOC
1
RED
2
RELAY
2
GREEN
3
SPEAKER
3
BLUE
RED
GREEN
BLUE
Advertisement
