Air Filter Maintenance - GENERGY EZCARAY Instructions For Use Manual

7 Remove the cap with oil level and put the oil into the engine through the
hole, until reach (without exceeding) the upper limit (H) of the level (see
figure below). To confirm the type of oil, see section 4.3 of the manual.
The estimated amount of oil to reach a correct level, per model is the following:
 Models less than 4000W
 Models greater than 4000W 1.1L
Use good quality
Recommended oil classification must be API "SJ" (USA) or ACEA "A3" (EUROPA)
or more updated (See container specifications).
8 Put the cap with oil level into the access hole, sealing the engine.
IMPORTANT: To safeguard the environmental regulations, the used oil must be
placed in a sealed container and delivered to a service station for recycling. Do not
put it in the trash or spill it on the ground.

9.2 Air filter maintenance.

NOTE: The dirt in the air filter reduces the air flow in the carburettor, limiting
its combustion and promoting serious engine problems. Clean the air filter
regularly, according to the maintenance plan in this manual. In dusty areas, filter
cleaning should be more frequent.
NOTE: The generator should never work without the air filter, otherwise we
will have a quick engine wear.
WARNING: Do not use gasoline or solvents with a low flash point to clean
the filter. They are flammable and explosive under certain conditions.
0.6L
four-stroke engine
72
oil SAE10W30 or SAE10W40.