Oil Filling And Checking - GENERGY EZCARAY Instructions For Use Manual

4.3 Oil filling and checking.

NOTE: The generator is delivered without oil. Do not attempt to start the
generator without adding oil in the engine first!
The generator has to be on a perfectly flat surface and levelled, to avoid an error
in the oil level reading.
Remove the cap with oil level and put the oil into the engine through the hole, until
reach (without exceeding) the upper limit (H) of the level (see the figure below).
The estimated amount of oil to reach a correct level, per model is the following:
 Models less than 4000W
 Models greater than 4000W 1.1L
Use good quality
Recommended oil classification must be API "SJ" (USA) or ACEA "A3" (EUROPA)
or more updated (See container specifications).
NOTE: The engine may consume a bit of oil during its running. Therefore,
before each usage, always check oil level and refill if necessary.
NOTE: Never use oils that are old, dirty, in poor condition or without
specifications (grade and quality). Do not mix different types of oils.
0.6L
four-stroke engine
51
oil SAE10W30 or SAE10W40.