Tools / Documents Required; Time Required; Safety Information - Siemens MOBILETT Plus Installation Instructions Manual

Prerequisites

Tools / documents required

•
Standard installation tools
•
Soldering iron
•
The document Service Instructions for the relevant MOBILETT
•
Set of ring spanners / open end keys, including a key for 5.5 mm diameter
•
Drill and drill bit for 5 mm diameter

Time required

•
Approximately 8 hours for one customer support engineer.

Safety information

WARNING
Siemens AG
Medical Solutions
Dangerous x-ray radiation and/or dangerous electrical voltage
during checks and adjustment work steps!
If not observed, death or serious physical injury can occur.
The following items must be complied with when performing ser-
vice work and tests:
- The product-specific safety information in the documents,
- The general safety information contained in ARTD Part 2.
•
Connect the MOBILETT only to a mains power supply outlet
(receptacle) that corresponds to the installation requirements of
VDE 0107 or to country-specific regulations.
•
Remove or install boards only when the generator is switched
OFF. Adhere to the ESD guidelines
•
Checks and adjustments performed with radiation ON are
identified by the radiation warning symbol
protective clothing must be worn for this type of adjustment (see
ARTD, Part 2).
SPR8-220.031.04
Rev. 04 09.03
.
. Radiation
Page 3 of 4 MOBILETT Plus/ -E/ -HP
CS PS 24
1 - 3
1
1
1