(Optional) Change Management Network Settings At The Cli - Cisco Firepower 1100 Getting Started Manual

Threat Defense Deployment with the Device Manager
scope ssa
show app-instance
Example:
Firepower# scope ssa
Firepower /ssa # show app-instance
Application Name
Version Cluster Oper State
-------------------- ---------- --------------- -------------------- ---------------
--------------- ------------------
ftd
Step 3 If you want to install a new version, perform these steps.
a) If you need to set a static IP address for the Management interface, see
Network Settings at the CLI, on page
You will need to download the new image from a server accessible from the Management interface.
b) Perform the

(Optional) Change Management Network Settings at the CLI

If you cannot use the default management IP address, then you can connect to the console port and perform
initial setup at the CLI, including setting the Management IP address, gateway, and other basic networking
settings. You can only configure the Management interface settings; you cannot configure inside or outside
interfaces, which you can later configure in the GUI.
Note
Procedure
Step 1 Connect to the threat defense console port. See
more information.
Log in with the admin user and the default password, Admin123.
You connect to the FXOS CLI. The first time you log in, you are prompted to change the password. This
password is also used for the threat defense login for SSH.
Note
Example:
Slot ID
1
Not Applicable
reimage procedure
You cannot repeat the CLI setup script unless you clear the configuration; for example, by reimaging. However,
all of these settings can be changed later at the CLI using configure network commands. See
Reference for Secure Firewall Threat
If the password was already changed, and you do not know it, you must reimage the device to reset
the password to the default. See the
(Optional) Change Management Network Settings at the CLI
Admin State Operational State
Enabled Online
91. By default, the Management interface uses DHCP.
in the FXOS troubleshooting
Defense.
Access the Threat Defense and FXOS CLI, on page 104
FXOS troubleshooting guide
Cisco Firepower 1100 Getting Started Guide
Running Version Startup
7.2.0.65
(Optional) Change Management
guide.
for the reimage procedure.
7.2.0.65
Command
for
91