Cisco Firepower 1100 Getting Started Manual page 131

Threat Defense Deployment with CDO
[...]
Hello admin. You must change your password.
Enter new password: ********
Confirm new password: ********
Your password was updated successfully.
[...]
firepower#
Step 3 Connect to the threat defense CLI.
connect ftd
Example:
firepower# connect ftd
>
Step 4
The first time you log in to the threat defense, you are prompted to accept the End User License Agreement
(EULA). You are then presented with the CLI setup script for the Management interface settings.
The Management interface settings are used even though you are enabling manager access on a data interface.
Note
Defaults or previously entered values appear in brackets. To accept previously entered values, press Enter.
See the following guidelines:
• Configure IPv4 via DHCP or manually?—Choose manual. Although you do not plan to use the
Management interface, you must set an IP address, for example, a private address. You cannot configure
a data interface for management if the management interface is set to DHCP, because the default route,
which must be data-interfaces (see the next bullet), might be overwritten with one received from the
DHCP server.
• Enter the IPv4 default gateway for the management interface—Set the gateway to be data-interfaces.
This setting forwards management traffic over the backplane so it can be routed through the manager
access data interface.
• Manage the device locally?—Enter no to use CDO. A yes answer means you will use the device manager
instead.
• Configure firewall mode?—Enter routed. Outside manager access is only supported in routed firewall
mode.
Example:
You must accept the EULA to continue.
Press <ENTER> to display the EULA:
End User License Agreement
[...]
Please enter 'YES' or press <ENTER> to AGREE to the EULA:
You cannot repeat the CLI setup wizard unless you clear the configuration; for example, by reimaging.
However, all of these settings can be changed later at the CLI using configure network commands.
See Command Reference for Secure Firewall Threat
Perform Initial Configuration Using the CLI
Defense.
Cisco Firepower 1100 Getting Started Guide
129