Cisco Firepower 1100 Getting Started Manual page 136

Perform Initial Configuration Using the Device Manager
The Management interface must have the gateway set to data interfaces. By default, the Management interface
receives an IP address and gateway from DHCP. If you do not receive a gateway from DHCP (for example,
you did not connect this interface to a network), then the gateway will default to data interfaces, and you do
not need to configure anything. If you did receive a gateway from DHCP, then you need to instead configure
this interface with a static IP address and set the gateway to data interfaces.
Step 5 If you want to configure additional interfaces, including an interface other than outside or inside that you want
to use for the manager access, choose Device, and then click the link in the Interfaces summary.
See Configure the Firewall in the Device Manager, on page 101
interfaces in the device manager. Other device manager configuration will not be retained when you register
the device to CDO.
Step 6
Choose Device > System Settings > Central Management, and click Proceed to set up the management
center management.
Step 7
Configure the Management Center/CDO Details.
Cisco Firepower 1100 Getting Started Guide
134
Threat Defense Deployment with CDO
for more information about configuring