Cisco Firepower 1100 Getting Started Manual page 134

Perform Initial Configuration Using the Device Manager
Example:
> configure network management-data-interface
Data interface to use for management: ethernet1/1
Specify a name for the interface [outside]: internet
IP address (manual / dhcp) [dhcp]: manual
IPv4/IPv6 address: 10.10.6.7
Netmask/IPv6 Prefix: 255.255.255.0
Default Gateway: 10.10.6.1
Comma-separated list of DNS servers [none]: 208.67.222.222,208.67.220.220
DDNS server update URL [none]:
Do you wish to clear all the device configuration before applying ? (y/n) [n]:
Configuration done with option to allow manager access from any network, if you wish to
change the manager access network
use the 'client' option in the command 'configure network management-data-interface'.
Setting IPv4 network configuration.
Network settings changed.
>
Step 6
Identify the CDO that will manage this threat defense using the configure manager add command that CDO
generated. See
Example:
> configure manager add account1.app.us.cdo.cisco.com KPOOP0rgWzaHrnj1V5ha2q5Rf8pKFX9E
Lzm1HOynhVUWhXYWz2swmkj2ZWsN3Lb account1.app.us.cdo.cisco.com
Manager successfully configured.
Perform Initial Configuration Using the Device Manager
Connect to the device manager to perform initial setup of the threat defense. When you perform initial setup
using the device manager, all interface configuration completed in the device manager is retained when you
switch to CDO for management, in addition to the Management interface and manager access settings. Note
that other default configuration settings, such as the access control policy or security zones, are not retained.
When you use the CLI, only the Management interface and manager access settings are retained (for example,
the default inside interface configuration is not retained).
Procedure
Step 1 Connect your management computer to the Ethernet1/2 interface.
Step 2
Log in to the device manager.
a) Enter the following URL in your browser: https://192.168.95.1
b) Log in with the username admin, and the default password Admin123.
c) You are prompted to read and accept the End User License Agreement and change the admin password.
Step 3 Use the setup wizard when you first log into the device manager to complete the initial configuration. You
can optionally skip the setup wizard by clicking Skip device setup at the bottom of the page.
Cisco Firepower 1100 Getting Started Guide
132
Onboard a Device with the Onboarding Wizard, on page 126
Threat Defense Deployment with CDO
to generate the command.