MikroTik LHG LTE18 Manual

LHG LTE18 kit
LHG LTE18 kit ( LHGGM&EG18-EA
Safety Warnings
Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing
accidents.
Ultimate disposal of this product should be handled according to all national laws and regulations.
All installation methods for mounting an access point on any wall surface are subject to the acceptance of local jurisdiction.
The Installation of the equipment must comply with local and national electrical codes.
This product is intended to be mounted outdoors on a pole. Please read the mounting instructions carefully before beginning installation. Failure to use the
correct hardware and configuration or to follow the correct procedures could result in a hazardous situation for people and damage to the system.
Use only the power supply and accessories approved by the manufacturer, which can be found in the original packaging of this product.
Read the installation instructions before connecting the system to the power source.
We cannot guarantee that no accidents or damage will occur due to the improper use of the device. Please use this product with care and operate at your
own risk!
In the case of device failure, please disconnect it from power. The fastest way to do so is by unplugging the power plug from the power outlet.
It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling
requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.
This is a class A device. In a domestic environment, this product might cause radio interference in which case the user might be required to take adequate
measures.
Exposure to Radio Frequency Radiation: This MikroTik equipment complies with the European Union radiation exposure limits set forth for an uncontrolled
environment. This MikroTik device should be installed and operated no closer than 56.5 centimeters from your body, occupational user, or the general
public.
Quickstart
1. While holding the unit by its central column, apply force to the tab, which holds the latch closed, until the latch pops open.
2. Insert the SIM card into the slot, with chips facing UP.
3. Assemble the case by attaching legs to the base of the unit, please see the
4. Mount the unit in your desired place, please see the
5. Connect an Ethernet cable (not included in the kit) to the Ethernet port, and connect the other end of the Ethernet cable to the included PoE
injector.
6. Plug the PoE injector into your PC.
7. Plug the included power supply into the PoE injector to start up the device. please see the
8. Set LAN computer IP configuration to
9. Open https://192.168.188.1
10. User name: admin and password on the label.
11. Update the device by clicking the "Check for updates" button on the right side and updating your RouterOS software to the latest version to
ensure the best performance and stability. Must have a valid SIM card inserted.
12. To manually update the device, please go
13. Choose ARM64 packages for this device and download them to your PC.
14. Upload downloaded packages to the WebFig "Files" menu and reboot the device.
15.
)
Mounting
automatic (DHCP).
in your web browser to start the configuration.
to https://mikrotik.com/download
Case assembly paragraph.
paragraph.
powering paragraph.