Table of Contents
Advertisement
Assembling the appliance:
- Install the five castors on the base (18).
- Install the body (15) into the base (18) , and use the base lock nut (20) to
screw on the base tightly.
- Connect power connection line (12 ), and put it into the main body (15),
and tight up by holder fixed screw (13).
- Install the back grill (6) , and tight up by grill lock nut (5) on the motor cover
(9)
- Install the blades (4) on to the motor shaft (8), and anticlockwise by blade
lock nut (3).
Installation
- Be sure to remove all packaging material from inside
the appliance.
- Ensure that the fan is switched off from the supply mains before start any
installation or assembly operation.
- The appliance should be used with its base fitted.
- Install misting board (1) on the front grill (2) and screw up by misting board
lock screws (3).
- Put the front grill (2) and back grill (6) together, and screw to fasten by grill
ring,and tight up by grill lock nut.
ATTENTION!
• Make sure the products unplugged from the mains before filling or refelling
the water tank.
• Only use water in the water tank. Do not add any chemicals, oils or other
additives.
• Only use cold or lukewarm water in the water tank. The water must not be
warmer than 40°C.
Place the fan on a dry and stable surface and insert the plug on the
socket; the unit will emit a short "BIP" sound indicating that pow er
is supplied. For your convenience the unit can be operated by using
control panel in the main body or by using remote control included.
3
Advertisement
Table of Contents
