dalap MISTY 40 Manual page 2

ATTENTION : read this booklet carefully it contains important
instructions for a safe installation, use and maintenance.
Important instructions to be kept for future reference.
It is forbidden for the children to play with the device.
This device must be used only for the purpose it was expressly
designed; any use not complying with the instructions contained in the
manual is considered inappropriate and dangerous. The manufacturer
is not responsible for possible damages caused by the inappropriate
and/or unreasonable use.
This device is NOT suitable to use it in an explosive environment (in the
presence of flammable substances such as gas, vapor, mist or dust, in
atmospheric conditions when, after ignition, the combustion is spread in
the air).
The packing materials (plastic bags, expanded polystyrene, etc.) must
be kept out of the reach of children or disabled persons since they
represent potential sources of danger.
The installation/assembly of the device will be made/ or according to the
indications of the manufacturer. A wrong procedure may cause
damages to persons, animals or objects, for which the manufacturer
cannot be considered responsible.
Place and use the device on a horizontal and stable surface.
Before use check the integrity of the device and power cable. In case
you are not sure contact a qualified person.
Before powering the device make sure the rating (voltage and
frequency) corresponds to the grid and the socket is suitable for the
plug of the device.
Make sure the power system is equipped with proper protection
according to the law in force.
DO NOT power the device using multiple sockets.
If possible, avoid the use of adapters and/or extension cables; if their
use is absolutely necessary, use only materials in compliance with the
current safety regulations and according to the electrical parameters of
the adapters.
The device must not be switched on using external timers and/or other
remote control devices which are not specified in this manual.
DO NOT use or store the device near heat sources (heaters, stoves etc.).
DO NOT dip the device in water or other liquids; in case the accidental
fall in the water DO NOT try to take it out, but first of all unplug
immediately the power cable from the socket.
If you use the device for the first time, make sure to remove any label or
protective sheet which blocks its proper functioning.
WARNINGS
1