Features - Ryobi RYI2000T Operator's Manual

KNOW YOUR GENERATOR
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
120 V AC RECEPTACLE
Your generator has two single phase, 60 Hz outlets that are
120 Volt AC, 15 Amp receptacles. These can be used for
operating appropriate appliances, electrical lighting, tools,
and motor loads.
AIR FILTER
The air filter help to limit the amount of dirt and dust drawn
into the unit during operation.
AUTO IDLE SWITCH
The auto idle switch is used to control the speed of the
engine and conserve fuel. When the switch is in the ON (I)
position and no appliances are connected to the unit, the
engine will idle. If an appliance is added, the engine speed
will increase to power the item. If the appliance is removed,
the engine will return to idle.
BATTERY CHARGING CABLE
The battery charging cable makes it easy to charge 12 Volt
lead acid batteries with the generator.
NOTE: Only use battery charging cable to charge vented
wet lead acid batteries.
CARRY HANDLE
The generator has a carry handle for easy transport.
CHOKE LEVER
The choke lever is used when starting the engine.
DC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator
against electrical overload.

FEATURES

DC RECEPTACLE
Your generator has a 12 V, 7.5 amp DC receptacle for
charging music players, cell phones, lead acid batteries,
and 12 V appliances.
WARNING:
The 12 V DC receptacle is designed to charge vented
wet lead acid batteries only. Other types of batteries may
burst, causing personal injury and damage.
ON/OFF SWITCH
The on/off switch is used in combination with the starter
grip and rope to start the generator. It is also used to turn
the generator off.
FUEL TANK
The fuel tank has a capacity of 1.0 gallon.
NOTE: The fuel flows from the fuel tank to the carburetor
only when the on/off switch is in the ON (I) position.
GROUND TERMINAL
The ground terminal is used to assist in properly ground-
ing the generator to help protect against electrical shock.
Consult with a local electrician for grounding requirements
in your area.
LED DISPLAY
LEDs provide feedback to indicate whether the generator is
in use, overloaded, or in need of lubricant.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
RETRACTABLE HANDLE
The generator is equipped with a retractable handle that can
be adjusted for storage and transportation.
STARTER GRIP AND ROPE
The starter grip and rope is used (along with the on/off switch)
to start the generator's engine.
VENTED FUEL CAP
The generator has a fuel cap with a vent that can be opened
and closed. During normal operation the vent should be in
the open position.
10 — English