Features - Ryobi RYi4022X Operator's Manual

PRODUCT SPECIFICATIONS
ENGINE
Engine Type:
Manufacturing # 099930627 or 099930628 ...... 212cc OHV
Replacement Spark Plug:
Manufacturing # 099930627 ......... LG F7RTC or equivalent
Manufacturing # 099930628 .....TORCH F6RTC or equivalent
Engine Lubricant Volume................... approximately 18 oz.
Fuel Volume ..............................................................3.3 gal.
*Rated output determined by PGMA Standard G300
KNOW YOUR GENERATOR
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
120 V AC RECEPTACLES
Your generator has two single phase, 60 Hz outlets that
are 120 Volt AC, 20 Amp receptacles and one 120 Volt AC
30 Amp RV receptacle. These can be used for operating
appropriate appliances, electrical lighting, tools, and motor
loads.
AC CIRCUIT BREAKER
The circuit breaker is provided to protect the generator
against electrical overload. The circuit breaker may be reset
by pressing the circuit breaker reset button.
AIR FILTER
The air filter helps to limit the amount of dirt and dust drawn
into the unit during operation.
AUTO IDLE SWITCH
The auto idle switch is used to control the speed of the
engine and conserve fuel. When the switch is in the ON (I)
position and no appliances are connected to the unit, the
engine will idle. If an appliance is added, the engine speed
will increase to power the item. If the appliance is removed,
the engine will return to idle.
AUTOMATIC SHUTOFF
The generator's carbon monoxide sensor is designed to
monitor the level of carbon monoxide present during gen-
erator operation. If the unit is positioned incorrectly and
carbon monoxide levels rise to an unsafe level, the LED on
the sensor will flash red and the generator will automatically
shut down. Leave the area immediately and relocate to an
open outdoor area. Ventilate the area thoroughly before

FEATURES

GENERATOR
Rated Voltage .............................................................. 120V
Rated Amps ................................................................... 28A
Rated Output*......................................................... 3,360 W
Starting Watts ......................................................... 4,000 W
Rated Frequency ........................................................ 60 Hz
occupying again. Ensure the generator is located in an
open, outdoor area and point exhaust away from occupied
structures before restarting.
NOTE: After a shutoff event has occured, the LED will con-
tinue to flash red for up to 20 minutes. Once the generator
is relocated and CO levels are safe, the generator can be
restarted even if the light is still flashing.
FUEL TANK
The fuel tank has a capacity of 3.3 gallons.
GROUND TERMINAL
The ground terminal is used to assist in properly grounding
the generator to help protect against electrical shock. Con-
sult with a qualified local electrician for grounding require-
ments in your area.
LOW OIL SHUT DOWN PROTECTOR
The low oil sensor causes the engine to stop if the level of
lubricant in the crankcase is insufficient. The engine may
not be restarted until sufficient engine lubricant has been
added to the generator.
OIL CAP/DIPSTICK
Remove the oil fill cap to check and add lubricant to the
generator when necessary.
OIL DRAIN PLUG
When changing the engine lubricant, unscrew and remove
the oil drain plug to allow old engine lubricant to be drained.
RESET BUTTON
The reset button is used to restore power if an overload
occurs. To restore power, remove the last electrical load
added, then depress the reset button.
STARTER GRIP AND ROPE
The starter grip and rope is used (along with the engine
switch) to start the generator's engine.
11 — English