Cleaning The Spray Gun; Maintenance - WAGNER FINE SPRAY Owner's Manual

C S
LEANING THE PRAY
WARNING
Special cleanup instructions for use with flammable solvents:
• Always flush spray gun preferably outside and at a hose
length from turbine.
• Area must be free of flammable vapors.
• Cleaning area must be well-ventilated.
1
Turn the turbine OFF.
2
Trigger the spray gun so
that the material inside the
spray gun flows back into
the container.
3
Unscrew the container.
Empty any remaining
material back into the
material container.
4
Pour a small amount of
the appropriate cleaning
solution into the cup
(warm, soapy water for
latex materials; mineral
spirits for oil-based
materials). Clean cup and
properly dispose of
cleaning solution.
5
Pour a small amount of
the appropriate cleaning
solution into the cup.
6
Attach the cup to the gun,
turn on the turbine, spray
the solution through the
gun for two seconds in a
safe area. Spray again
for two seconds. Properly
dispose of remaining
cleaning solution.
7
Turn turbine OFF.
8
Wipe the exterior of the cup and gun until clean.
English
C
G
UN
LEANUP
9
Unscrew the nut and
remove the air cap and
nozzle.
10
Clean the container,
suction tube, air cap
and nozzle with a
cleaning brush and the
appropriate cleaning
solution.
Never clean nozzle or air holes in the spray gun with sharp
metal objects.
M
AINTENANCE
You should inspect the air filter in the turbine to see if it is
excessively dirty. If it is dirty, follow the steps below to
replace it.
1
Insert a straight-slot screwdriver through one of the slots in
the rear of the turbine.
2
Pry the filter cover from
the turbine.
3
Remove the dirty filter
from the filter cover and
replace with a new one.
The smooth side of the
air filter must be placed
toward the turbine.
4
Secure the cover back onto the turbine.
Never operate your unit without the air filter. Dirt could be
sucked in and interfere with the function of the unit.
6 © 2003 Wagner Spray Tech. All rights reserved.
CAUTION
CAUTION