Weslo PURSUIT 640s User Manual page 5

4. Slide the Handlebar Collars (12) onto the
Handlebars (6). Attach the Handlebars to the
Scissor Frame (3) with eight M5 x 12mm Screws
(19). Next, slide the Handlebar Collars down over
the Screws.
5. The Console (48) requires two 1,5v batteries (not
included). Alkaline batteries are recommended.
Refer to the inset drawing. Remove the battery door
from the Console. Press two batteries into the bat-
tery compartment. Make sure that the negative
ends of the batteries (marked "–") are touching
the springs in the battery compartment. Reattach
the battery door.
Slide the Console (48) onto the console plate. Make
sure that the plastic clip on the back of the Console
snaps into the tab on the console plate.
Connect the console wire to the Reed Switch Wire
(49).
Note: The console on your exercise cycle may
not look like the one pictured in this section, but
it will function the same way.
6. Identify the Left Pedal (8). (The Left Pedal is
marked with an "L.") Using an adjustable spanner,
tighten the Left Pedal counterclockwise into the left
arm of the Crank (53).
Tighten the Right Pedal (9) (not shown) clockwise
into the Right arm on the Crank.
7. Make sure that all parts are properly tightened before you use the exercise cycle. Place a mat under
the exercise cycle to protect the floor or carpet. Note: Some hardware may be left over after assembly is
completed.
All manuals and user guides at all-guides.com
5
4
6
12
12
19
3
5
Console
Wire
48
Console
Plate
6
8
53
19
49 48
Batteries
Battery Door
3