Items Supplied; Additional Accessories - Evolution R150 RCP-Li Original Instructions Manual

Kickback is the result of saw misuse and/or
incorrect operating procedures or conditions and
can be avoided by taking proper precautions as
given below.
a. Maintain a firm grip with both hands on the saw
and position your arms to resist kickback forces.
Position your body to either side of the blade, but
not inline with the blade.
b. When blade is binding, or when interrupting
a cut for any reason, release the trigger and hold
the saw motionless in the material until the blade
comes to a complete stop. Never attempt to
remove the saw from the work or pull the saw
back- ward while the blade is in motion or
kickback may occur.
c. When restarting a saw in the work-piece, center
the saw blade in the kerf and check that saw teeth
are not engaged into the material.
d. Support large panels to minimize the risk of
blade pinching and kickback.
e. Do not use dull or damaged blades.
Unsharpened or improperly set blades produce
narrow kerf causing excessive friction, blade
binding and kickback.
f. Blade depth and bevel adjusting locking levers
must be tight and secure before making cut. If
blade adjustment shifts while cutting, it may cause
binding and kickback.
g. Use extra caution when sawing into existing
walls or other blind areas. The protruding blade
may cut objects that can cause kickback.
Service
Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
SERIAL NO. / BATCH CODE
The serial number can be found on the motor
housing of the machine. For instructions on how
to identify the batch code, please contact the
Evolution Power Tools helpline or go to:
www.evolutionpowertools.com
www.evolutionpowertools.com

ITEMS SUPPLIED

Instruction Manual
Cordless
reciprocating saw
1 x multipurpose blade
1 x thin steel blade
4mm Hex key
2Ah Battery
4Ah Battery
5Ah Battery
8Ah Battery
Single dock charger
Double dock charger

ADDITIONAL ACCESSORIES

In addition to the standard items supplied with
this machine the following accessories are also
available from the Evolution online shop at
www.evolutionpowertools.com or from your
local retailer.
Description
Multipurpose & thin
steel blade pack
Green & general
wood blade pack
RECOMMENDED BATTERIES/CHARGERS
Description
2Ah Battery
R18BAT-Li2,
R20BAT-Li2
4Ah Battery R18BAT-Li4,
R20BAT-Li4
5Ah Battery R18BAT-Li5,
R20BAT-Li5
8Ah Battery R18BAT-Li8,
R20BAT-Li8
R18RCH-Li1- Single R18RCH-Li1,
dock charger R20RCH-Li1
R18RCH-Li2 - Dou- R18RCH-Li2,
ble dock charger R20RCH-Li2
If you intend to store a battery for a period without
use then store battery at room temperature (0°C
to 20°C) When storing for very long periods boost
charge the battery once per year to prevent over
discharge. The Ambient temperature range for
tool and battery use: 0°C to 40°C. The charging
temperature: 5°Cto 40°C.
8
104-0001, 104-0001A,
104-0004 104-0001B,
104-0001C
104-0004A
Part No
045-0255
045-0254
Part No
EBAT18-Li-2
EBAT18-Li-4,
EHPB18-Li-4
EBAT18-Li-5
EHPB18-Li-8
EFC18-Li
EMC18-Li