Bimetal thermometers for asphalt temperature (2 pages)
Summary of Contents for SATO KEIRYOKI SK-1110
Page 1
Instruction Manual No.8014-03 Digital Thermometer (K Type Thermocouple) Model SK-1110 3-4, Kanda-kajicho, Chiyoda-ku, Tokyo 101-0045 Japan URL: http://www.sksato.co.jp/english/...
Page 3
- Dispose of used batteries according to your local waste disposal regulations for environmental conservation. - Do not wash or wipe the SK-1110 with alcohol, thinner or any other solvents. If the unit needs to be cleaned, wipe it with a tightly-wrung towel or the like that has been dipped in warm water with a neutral detergent.
Page 4
Overview The SK-1110 is a digital thermometer which measures temperature with a K type thermocouple sensor probe connected. The measurement range of SK-K010 standard probe is -50 to 300°C. Indicated value is conforming to ITS-90 (the International Temperature Scale Standard).
Names and Functions of Components 1. Main unit Front View Rear View Upper View ① Display section: Measured temperature and characters of current states are displayed. ② Keys for operation: POWER key Press this key to turn the main unit on (measurement mode). Press this key again to turn off.
Page 6
2. Display section ⑦ Upper display: Displays the temperature measured ⑧ Lower display: Displays the standard temperature readings in OFFSET mode. Displays the Max or Min. temperature readings in MAX/MIN mode. Displays the average temperature readings in AVG mode. Note: When these functions are not activated, comma is displayed. ⑨...
Page 7
Fitting the vinyl cover over the unit The SK-1110 comes with a vinyl cover that fits on the unit. With the cover in place, the thermometer can be used even when your hands are wet. The cover also keeps the unit clean and dry.
Page 8
(2) Press the PWR key to turn on the main unit. Upon initial power-on of the SK-1110, the LCD displays all the elements for about one second before the measurement mode starts.
Page 9
Note: The OFFSET function is disabled when the maximum/minimum, average or memory data is displayed. Maximum or minimum value display function The SK-1110 can display the highest temperature (maximum value) or the lowest temperature (minimum value) measured after the MX/MN key is pressed. During this time, the label "MX"...
Page 10
Average display function The SK-1110 displays the average temperature among the temperatures measured since the AVG key was pressed. These values are obtained by summation averaging (up to about 4 hours). While the AVG function is activated, the current temperature measured is displayed in the upper display and the average temperature is displayed in the lower display.
Page 11
3. Clearing data in memory (1) Turn off the SK-1110. (2) Press the MEM and PWR keys together to turn on the unit. Release the MEM key when the display shows the following image. (3) Use the ▼ key to select a memory clearing option.
Page 12
Troubleshooting Some of the following phenomena may not be considered defective. Check the phenomena carefully before requesting repair. Abnormal phenomenon Possible cause(s) Action(s) to be taken The batteries have run out. Replace with new batteries. If the power will not turn on If the parts have been damaged, even after properly inserting ask your Sato sales representative...
Page 13
Specifications Name Jumbo LCD Digital Thermometer (K Type Thermocouple) Model SK-1110 Cat. No. 8014-03 Number of channel 1 channel Measuring range -50 to 1300ºC Display range -73.3 to 1371.0ºC ±(0.5%rdg + 1) ºC at -50 to 0.0ºC Accuracy (main body) ±(0.3%rdg + 1) ºC at 0.1 to 1000ºC...
Page 14
Standard Probes Model SK-K010 Type of Thermocouple : K type (CA), Class 1 Measuring range : -50 to 300ºC ① Sensing part : ø2.3 x 150 (L)mm (Material: SUS316) : ø17.5 mm (max.) ② Grip ③ Sensor cord : 0.75 m ④...
Page 16
3-4, Kanda-kajicho, Chiyoda-ku, Tokyo 101-0045 Japan URL: http://www.sksato.co.jp/english/...
Need help?
Do you have a question about the SK-1110 and is the answer not in the manual?
Questions and answers