Table of Contents
Advertisement
Cancelling the delay start
Press the on/off button for 3 seconds until the
appliance is in programme selection mode.
When you cancel the delay start, you have to set
the programme again.
Cancelling the programme
Press the on/off button for 3 seconds until the
appliance is in programme selection mode.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
The Auto Off function
This function decreases energy consumption by
deactivating automatically the appliance when it is
not operating.
HINTS AND TIPS
GENERAL
Follow the hints below to ensure optimal cleaning
and drying results in daily use and to protect the
environment.
•
Washing dishes in the dishwasher as instructed
in the user manual usually consumes less water
and energy than washing dishes by hand.
•
Load the dishwasher to its full capacity to save
water and energy. For best cleaning results,
arrange items in the baskets as instructed in the
user manual and do not overload the baskets.
•
Do not pre-rinse dishes by hand. It increases
the water and energy consumption. When
needed, select a programme with a prewash
phase.
•
Remove larger residues of food from the dishes
and empty cups and glasses before putting
them inside the appliance.
•
Soak or slightly scour cookware with firmly
cooked-on or baked-on food before washing it
in the appliance.
•
Make sure that items in the baskets do not
touch or cover each other. Only then can the
water completely reach and wash the dishes.
•
You can use dishwasher detergent, rinse aid
and salt separately or you can use the multi-
tablets (e.g. ''All in 1''). Follow the instructions
on the packaging.
•
Select a programme according to the type of
load and the degree of soil.
most efficient use of water and energy
consumption.
•
To prevent limescale buildup inside the
appliance:
– Refill the salt container whenever
necessary.
12
The function comes into operation:
•
When the programme is complete.
•
After 5 minutes if a programme was not started.
End of the programme
When the programme is complete, the Auto Off
function switches the appliance off.
Close the water tap.
– Use the recommended dosage of the
– Make sure that the current level of the water
– Follow the instructions in the chapter "Care
USING SALT, RINSE AID AND DETERGENT
•
Only use salt, rinse aid and detergent designed
for dishwasher. Other products can cause
damage to the appliance.
•
In areas with hard and very hard water, we
recommend to use basic dishwasher detergent
(powder, gel, tablets containing no additional
agents), rinse aid and salt separately for optimal
cleaning and drying results.
•
Detergent tablets do not fully dissolve with short
programmes. To prevent detergent residues on
the tableware, we recommend that you use
tablets with long programmes.
•
Always use the correct quantity of detergent.
Insufficient dosage of detergent can result in
poor cleaning results and hard-water filming or
spotting on the items. Using too much detergent
with soft or softened water results in detergent
residues on the dishes. Adjust the amount of
detergent based on the water hardness. Refer
to the instructions on the detergent packaging.
•
Always use the correct quantity of rinse aid.
offers the
Insufficient dosage of rinse aid decreases the
drying results. Using too much rinse aid results
in bluish layers on the items.
•
Make sure that the water softener level is
correct. If the level is too high, the increased
quantity of salt in the water might result in rust
on cutlery.
detergent and rinse aid.
softener agrees with the hardness of the
water supply.
and cleaning".
Hide quick links:
Advertisement
Table of Contents
