Advertisement
IG21, IG21R and IG31R Hardware Installation Guide
DIN Rail Mounting Instructions for IG21, IG21R and IG31R
You are now ready to attach the DIN rail bracket to support either a Vertical or Horizontal mounting of the IG21R or IG31R. Refer to
the appropriate section noted below:
Attaching the DIN Rail Bracket to Support Vertical Mounting, page 5
Attaching the DIN Rail Bracket to Support Horizontal Mounting, page 6
Figure 2
Attaching Adapter Plate to the IG21R or IG31R
Attaching the DIN Rail Bracket to Support Vertical Mounting
After you attach the DIN Rail (as shown in
1.
Position the bracket over the four mounting holes as shown in
2.
Attach the Adapter plate to the back of the IG21R or IG31R using the four screws provided and applying 13-15 inch-pound torque.
The screw thread diameter is 4.0 mm, the screw head diameter is 8.0 mm, and the screw length is 4.7 mm.
3.
Attach the Din Rail Bracket using two screws as shown in
5.5 mm, and the screw length is 7.0 mm.
Figure
3), do the following:
Figure
Figure
3. The screw thread diameter is 3.0 mm, the screw head diameter is
5
3.
Advertisement
