RocketFish RF-RBREC User Manual page 8

Sender front panel
# Feature
Standby LED
1
Power/Join
2
button
Power/Join
indicator
3
HD A/B indicator Lights when the high definition function is activated.
4 & 10
HD A/B button
5 & 9
Source A/B
button
6 & 8
Source A/B
7
indicator
8
TM
2 3
4
1 5
Turns red when the sender is in standby mode.
Press to turn the sender on. Press and hold to initiate joining. Press again to go to
standby. When the AC adapter is plugged in, the Sender automatically powers up.
Lights steady in power-on mode (green when the Hub Enable switch is set to "Enable."
Blue when the Hub Enable switch is set to DISABLE)
Blinks quickly in joining mode.
Blinks slowly when the device is not part of a network or the hub is not powered.
Press repeatedly to toggle between CD and HD audio link modes for input A and input
B respectively. When the HD function is activated, the audio quality will be enhanced.
Press to enable the source to be transmitted onto the network and press again to
disable the source. The status will be shown on the indicator. Make sure your hooked
up speaker outputs match the enabled source, sound will not be sent unless the inputs
connected have a corresponding activated source.
LED is illuminated steadily when a source is being transmitted. LED is off when no
source is enabled. LED blinks for a short while when a receiver selects this source to
listen to.
6
7 8 9 10